You must check 2 or 3 axis boxes for locking to occur. If you want to stretch in all 2 or more directions at the same time, check the Lock dimensions in these axes check boxes. Click an arrow to stretch in that direction. Percentage Enter a percentage and click an arrow to stretch the component, or selected entities, along an axis. You can also return to this tab after performing a percentage or incremental stretch to see what the new dimensions are. Enter the desired size in any of the directions and click Apply to perform the stretch. There are 3 tabs available for stretching.ĭimensions Shows the current size of the component or entities selected. (Since this is a Dynamic Component, more rungs were added to the back.) Click one of the colored arrows to shrink or expand the component along that axis.Select the Stretch type desired - New Dimensions, Percentage, or Incremental Add-on.Click the Stretch Icon on the RpTools Toolbar.Select the Component or geometry to stretch.Use Component Axes - If the selection is a single component, this option will rotate the selection about its original axes, rather then the model axes.To spin an item placed on the floow, use the positive or negative Z arrows. Click an arrow to rotate around an axis.If you set a small angle such as 15 or 30 degrees, then you can click the arrow several times to get a larger rotation. The radio buttons will prefill some common angles. (Solid Blue rotates clockwise around the blue axis.) Select an arrow for the axis to Rotate about.Use the Rotate By settings in the lower half of the menu select or enter desired rotation.Click the Rotate icon on the RpTools toolbar. ![]() This can be used to mirror furniture in a room or workstation across a hall or aisle. ' Gap is the distance which will be placed between the selection entities and the mirrored entities.Click any of the colored arrows to mirror the current selection in along the corresponding red, green or blue axis.Blue mirror operations are reflected through a plane parallel to the ground plane. Red and Green mirror operations are reflected through a plane perpendicular to the ground plane (red/green). Click the arrow for the direction of the desired mirror.ĭesk Mirrored along Red Axis with a 2' gap.Enter a gap to leave between objects after mirroring.Click the Mirror icon on the RpTools toolbar.(Useful for mirroring "handed" furniture components.) Note:Mirroring is only in the Red.Green plane not in the Blue Axis. Mirror works like Copy, except that the geometry is mirrored around an axis. Otherwise the selection is moved along the model axes. If it is checked, the component will be copied along its own axes. Use component axes - This is enabled only if a single component instance is selected.If you click an arrow (again), a new copy will be made in that direction. After the copy, the new entities are selected.Enter the distance to move when making the copy below, and click an arrow to copy in that direction.Make a copy of a component 3' along the red axis Click the arrow in the direction you want to copy,.(Red = X, Green = Y, Blue = Z.)Ĭopy Selection works like Move Selection, except that a new copy of the selected items is created, rather than just moving the items. ![]() If it is checked, the component will be moved along its own axes. Use component axes - This is enabled only if a single component instance is selected. ![]() If you make a mistake, you can clock the opposite arrow to return, or use Undo. If you want to move in two directions, move along one axis, then enter the other distance and move along the other axis.)Įnter the distance to move below, and click an arrow to move in that direction. (The angular arrows move the total distance at 45 degrees. ![]() (The arrows are colored to match the red, green and blue axes.) Click an arrow for the direction to move.Type in a distance desired (or use the up and down sliders).Click the Move icon on the SpaceDesign toolbar.Select a Component or geometry to place.In this example, we want to move an component exactly 3' along the red axis. The Move Wizard is useful for more exact positioning.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |